Vehicles

Rockwell recalls

35 recall campaigns on record, 0 in the last 12 months. Pick your model, or enter your VIN.

Check your Rockwell

or pick your car

The VIN is on the driver's side of the dashboard and on your registration. A recall lists every vehicle it covers; how to check yours and get the free repair.

Popular Rockwell models

Rockwell24 recalls Brake Drum2 recalls Q-Plus Brakes1 recalls TK Axle1 recalls U-Joints1 recalls Front Drive Steering Axle1 recalls Brake Shoe Assy1 recalls System Saver 10001 recalls System Saver Twin1 recalls 3219-P-50341 recalls FC1 recalls FD1 recalls FF1 recalls FG1 recalls FL1 recalls ECU1 recalls

All 17 Rockwell models, A to Z

All recent Rockwell recalls

Nov. 19, 1997Rockwell ECU: Antilock/traction control/electronic limited slip Equipment description: antilock braking System (ABS) Electronic Control Units (ECU) for Over-The-Road Trailer applications. The cover Seal (O-ring)…
April 11, 1995Rockwell FC, FD, FF and others: Tie rod assembly During Assembly, The Tie rod end nuts were not properly torqued. Extremely low torque Can allow movement between The ball stud And The Tie rod arm…
March 22, 1995Rockwell System Saver 1000, System Saver Twin: Hoses, lines/piping, and fittings Air System blockage in The Air dryer occurs degrading The moisture removing capabilities of The dryer when The Vehicle is operated in a cold…
Jan. 18, 1995Rockwell 3219-P-5034, Brake Drum: Drum The machining performed on The Brake drums will not permit The Drum to Seat fully against The hub face. The reduced Brake Drum And hub contact area…
March 12, 1993Rockwell Front Drive Steering Axle: Tie rod assembly The High Strength -- low Alloy material which was used in The turnbuckle style Cross-tube Axle assemblies has low impact resistance properties. The…
Jan. 22, 1993Rockwell Brake Shoe Assy: Drum The Brake assemblies do not meet The Brake Power And Brake recovery sections of FMVSS 121 "Air Brake Systems".
Jan. 24, 1992Rockwell U-Joints: Universal joint The interaxle Driveline u-Joints May fail at low mileage due to lack of lubrication in The u-joint in The Assembly Process.
Aug. 14, 1991Rockwell TK Axle: Spindle Axles May develop fatigue cracks in Axle spindle that could propagate into a transverse crack.
June 6, 1991Rockwell Rockwell: Linkages Due to operational conditions, Steering arms could crack And break.
June 6, 1991Rockwell Rockwell: Linkages Steering arms crack And break from pressures exerted in operations in urban traffic environemnts.
Dec. 26, 1990Rockwell Rockwell: Tie rod assembly Improper heat treatment of Tie rod arms causes arms to be subject to yielding And fatigue cracks.
Oct. 9, 1990Rockwell Q-Plus Brakes: Antilock Trailer Axle assemblies May contain shoe And lining assemblies that do not comply with The Brake retardation force Performance requirements of FMVSS…
Sept. 5, 1990Rockwell Brake Drum: Drum Hub mounting face diameter of Drum May be improperly machined causing a Line contact interference of The hub And Drum Assembly, loosening of The…
June 12, 1990Rockwell Rockwell: Linkages Steering arm May fracture due to Environmental, maintenance, or other factors.
May 4, 1990Rockwell Rockwell: Spindle A number of factors could cause longitidunal And - or transverse cracks in The spindle end that could lead to spindle end failure And separation of…
May 17, 1989Rockwell Rockwell: Springs Incorrectly welded Suspension brackets to The Axle housing May cause premature failure of The holding bracket Weld.
March 22, 1989Rockwell Rockwell: Spindle Fracture of The spindle end And separation of The Dual Wheels from The Vehicle.
Jan. 17, 1989Rockwell Rockwell: Non-powered axle assembly Due to Metal fatigue, cracking And breaking of The front Axle Beam Center could occur.
April 8, 1988Rockwell Rockwell: Drum Original specified rear Brake drums Are inadequate in Strength for Brake loads being imposed on these drums.
April 29, 1987Rockwell Rockwell: Hanger/bracket The Spring hanger bracket May contain incorrect welds.
June 9, 1986Rockwell Rockwell: Arm The Brake mounting nuts which fasten The two Brake assemblies to The Axle knuckle on The front Steering Axle assemblies or The Wheel end kits were…
March 1, 1985Rockwell Rockwell: Arm Front Axle Beams contain "shear cracks" at The Beam ends where The King pins And Steering knuckles Are attached. Consequence of defect: if failure of…
Sept. 11, 1984Rockwell Rockwell: Banjo housing
May 10, 1982Rockwell Sewer Rodder: Labels The involved Vehicles do not conform to Federal Motor Vehicle Safety Standard no. 108, "lamps, reflective devices, And associated Equipment". Also…
April 1, 1982Rockwell Rockwell: Steering wheel/handle bar Some Universal joint yokes were forged with incorrect Steel, resulting in brittle welds between The yoke And its mating shaft. Field Service loads…
July 13, 1979Rockwell Rockwell: Wheels Cracks May develop in The Radial spokes near The hub. These cracks could propagate And May eventually cause hub failure. Hub failure could allow The…
Jan. 10, 1978Rockwell Rockwell: Multi piece On The involved Vehicles, casting deficiences exist in The area of The Wheel mounting flange or The inner Wheel Bearing. When a flange failure…
Dec. 1, 1977Rockwell Rockwell: Hub The involved hubs May develop cracks in The area of The Wheel mounting flange. Eventually, The hub could fail causing The flange along with The Wheel…
Sept. 12, 1977Rockwell Rockwell: Multi piece The involved Aluminum hubs May develop cracks in The barrel between The inner And outer Bearing, which could lead to hub failure. Upon failure, The…
Jan. 13, 1977Rockwell Rockwell: Wheels The involved Vehicles May have been equipped with defective hubs in that they May develop cracks which could lead to hub failure.
Nov. 1, 1976Rockwell Rockwell: Hub
May 25, 1976Rockwell Rockwell: Banjo housing
Feb. 24, 1976Rockwell Rockwell: Hub
July 15, 1975Rockwell Rockwell: Antilock
May 23, 1975Rockwell Rockwell: Control unit/module